Hello Guest it is March 29, 2024, 09:16:34 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - PLASTICSALES

Pages: 1
1
General Mach Discussion / Proximity sensor help required
« on: August 19, 2013, 07:49:29 AM »
Can anyone help I have a new PLCM 3 break out board.
I am trying to set up proximity sensors for all axis including homing, the sensor is 6 to 26 volt 300 mA 3 wire NO type.
I am powering using 12 v as this is what was shown in the break out board manual.

When I put volt meter on the terminals on the BOB I only get 1.6 volts when metal is applied I get 0 volt
The led on the mother board works ie goes off when metal sensed.
Mach3 does nothing no screen leds and does not stop motor when metal applied.
Ports and pins are set correctly I am sure.

Can anyone advised me, am i using the wrong size resistance sensor?

Pages: 1