Hello Guest it is March 28, 2024, 07:37:22 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Ebygum

Pages: 1
1
General Mach Discussion / MACH 3
« on: February 16, 2019, 10:01:02 PM »
Gday,
I have a problem in Mach3 where the machine does not cut out in the orientation as per the display.
Please find attached a diagram showing what is displayed and what is actually cut.
The circle and triangle are cut in the opposite corners not as shown in the display.


Any help would be appreciated.

Trevor

2
General Mach Discussion / Work coordinates
« on: October 31, 2017, 04:32:01 AM »
Gday,
After setting up my limits and all working fine.
I setup G59 as per coordinates but when I tried to send the machine to these coordinates the X & Y worked perfect but the Z didn't move.
If I had any hair it would be in jeopardy.
Any assistance would be much appreciated.

cheers

Trevor

Pages: 1