1
General Mach Discussion / DDSM6V5.0 + DDREAM mach3 manual control box
« on: February 16, 2016, 07:54:32 PM »
Purchased these two items. The manual control box seemed like much easier way to control 4 axis small mill I have. Works Great in jog. When I execute a G code program, it begins OK. At a random G code block, X or Y or both, will slowly begin jogging while program continues to execute. Must RESET to avoid a wreck. It like the DDSM6 is requesting a jog at same time the G code continues to execute. PC is Gateway notebook LT400u running Windows 7 pro. No other USB ports in use. I go into Windows CONTROL PANEL and SERVICES; STOP all auto update services. Same fault.
ANY HELP OR THOUGHTS WILL BE GREATLY APPRECIATED!!!
Purchased Mach4 rev 66 about year ago and a SMART STEPPER which was working great. I removed DDSM6 and reconnected SMART STEPPER. Mill runs perfectly, but harder to use without manual control box.
ANY HELP OR THOUGHTS WILL BE GREATLY APPRECIATED!!!
Purchased Mach4 rev 66 about year ago and a SMART STEPPER which was working great. I removed DDSM6 and reconnected SMART STEPPER. Mill runs perfectly, but harder to use without manual control box.