Hello Guest it is May 16, 2021, 11:59:29 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - gavna77

Pages: 1
1
General Mach Discussion / No Y axis movement from G code
« on: July 28, 2013, 11:58:45 AM »

Hi All,
I hope you can help!

I don't seem to have any Y axis movement when i run a program to cut.
I can jog and everything works and even run a drilling program and everything works but when i run a cutting program the head will move to the correct starting poiint using x,y and z axis but then wont move the y axis when cutting?

Thanks in advance
Gav

Pages: 1