Topics

1

General Mach Discussion / Toolpath Screen

« on: July 16, 2006, 12:10:28 AM »

Hi,

I have recently downloaded version 1.090.064 onto my computer, can anyone tell me why my toolpath screen looks like the attached file.


Kind Regards

Bill S.

2

General Mach Discussion / Cutter marking wood

« on: July 01, 2006, 03:47:16 PM »

Hi all.

I have a small problem whilst cutting Mach3 does not appear to be reading the program too well I think, My cutter is cutting in a  jerky  motion, can anyone tell me what the problem is.

Thanks Bill S

3

General Mach Discussion / Inch and mm

« on: April 24, 2006, 02:51:57 PM »

Hi all,
can anyone tell me how I can use mach 3 for both Inch and mm.

Kind Regards

Bill S

4

General Mach Discussion / 2 axis running

« on: April 04, 2006, 10:59:46 AM »

Hi all,
I am a newbie and I am running Mach 3.
The problem I am having is to do with running  2 axis together, I am using the soft limits only at this time, and if I run for instance x and y together using my cursor keys and X axis reaches home first Y axis stops also and, will not start again on the first press of the button on the key pad all I get is my motors growling at me, but it will move OK on the second press of the button this happens no matter which 2 axis I run together.
Can anyone tell me what the problem is.

Kind Regards

Bill S

5

General Mach Discussion / Lost Screen

« on: March 22, 2006, 04:21:47 PM »

Hi,

New to all this, I tried out the new screen "Shift Key" and ended up with no screen at all on program load up, assistance would be appreciated.

Bill s.