Hello Guest it is March 29, 2024, 02:56:11 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - emi

Pages: 1
1
General Mach Discussion / Mach3 setup for 4axis hot wire
« on: June 27, 2013, 04:43:10 PM »
Hey i need help with  setting up 4axis hot wire I'm
using g540 gecko 4axis setup.
 I have X and A as a slave i can jog 2 motors with up or down arow
How do i slave Y and B axis so i can jog in sync with lets say arrow key?
i did try sys hotkeys set same key for Y y++38 y-40 B b++38 b-40 no results only one motor moves
Did try formulas  put f(y)=b still nothing.
amateur at best need help!

Pages: 1