Hello Guest it is March 28, 2024, 12:09:51 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Greenjeens

Pages: 1
1
General Mach Discussion / mach 3 direction problem
« on: July 18, 2013, 11:57:51 AM »
My home is at the bottom left corner, or closest to me left corner.  Here is the issue.  My machine will be homed, then I jog by pressing the right arrow key, the crosshairs move to the left on the display.  I jog to the bottom my corss hairs move to the top.  Its like mach3 thinks my table is all opposite.  I have fiddled with reversing the axes in Homing/limits, and also in the ports and pins and I cant get the cross hairs to move and stay on my material sheet.  Any suggestions?  Seems like a very simple problem but I just cant figure it out.
A little background on what I have
49"x49" table size
Mach 3, Sheetcam, Inkscape
3, 333oz motors on X, Y, 425oz on floating torch z axis.
Ghecko 540, im using the G540 xml
keling 48v 7.3 amp supply.

Maybe someone can tell me how to upload my XML, and maybe you fine people could possibly take a look and see what the deal is.  Any help is appreciated.

Pages: 1