1
General Mach Discussion / z axis not moving after sometime DRO shows that is moving
« on: May 14, 2007, 02:16:16 AM »
Hi everybody,
yesterday I was working on a program that Graham had helped me with in my last topic and i was drilling-tapping almost 100 holes.After sometime Z motor stopped moving while the DRO was showing that it was...!. I tried to move the axis by the handwheel and it was moving freely as if there was no power to the axis motor.!!!.I closed the power to the board and reopened it and then it worked O.K. for a while but then it did it again! I shut down both the machine and the PC and after 4-5 hours I tried again and it worked O.K.!! Do you think it is a problem of the driver (I use Geckos 202s) or the motor or even the board (I use Sound Logic's Combo PCB) or MACH3?
Your help would be much appreciated!!
Biz
yesterday I was working on a program that Graham had helped me with in my last topic and i was drilling-tapping almost 100 holes.After sometime Z motor stopped moving while the DRO was showing that it was...!. I tried to move the axis by the handwheel and it was moving freely as if there was no power to the axis motor.!!!.I closed the power to the board and reopened it and then it worked O.K. for a while but then it did it again! I shut down both the machine and the PC and after 4-5 hours I tried again and it worked O.K.!! Do you think it is a problem of the driver (I use Geckos 202s) or the motor or even the board (I use Sound Logic's Combo PCB) or MACH3?
Your help would be much appreciated!!
Biz