1
General Mach Discussion / Un expected pop up window during tool change
« on: August 17, 2011, 11:22:04 AM »
I am using the latest version of Mach 3. During a tool change I had a pop up window that displayed a tag for each axis with what looked like the distance I jogged from the position that motion stopped when the "Tool Change Stop" happened. At the bottom of the pop up were two choices: "OK" or Cancel. Since I had never seen this window I selected "Cancel" then hit the start button as usual. Unfortunately the spindle did not start and before I could get the stop button hit I snapped the tool.
What is this window?
Help, I am afraid to start this job over again ( it runs over 4 hours )
John B
What is this window?
Help, I am afraid to start this job over again ( it runs over 4 hours )
John B