1
General Mach Discussion / FeatureCam
« on: December 26, 2013, 11:33:00 AM »
Need some coaching....
Trying to run current trial version of Mach3
Using Featurecam 2014
seems to have trouble processing/executing G2 and G3 codes
Have i & j codes set to incremental
Mach3 just stops when it hits a G2 or G3 code
Roger Olson 423-742-4583
Trying to run current trial version of Mach3
Using Featurecam 2014
seems to have trouble processing/executing G2 and G3 codes
Have i & j codes set to incremental
Mach3 just stops when it hits a G2 or G3 code
Roger Olson 423-742-4583