Hello Guest it is September 27, 2023, 07:48:13 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - Ed123

Pages: 1
General Mach Discussion / Dimensions twice what they should be
« on: May 22, 2013, 06:13:13 PM »
I have calibrated all axes and they measure what I put into the software.
However, when running a simple rectangle program the dimensions are twice what they should be.
Any suggestions as to how to correct this.\?

General Mach Discussion / Printer port
« on: May 19, 2013, 03:01:42 PM »
I downloaded Mach3 as instructed and did the reboot before using Mach3.  However, when I go to tune the axis Mach3 does not allow me to select the axis I wish to set.  Also when in the program option I cannot jog the axes.  I assume that the printer driver is not loaded in the computer.
The computer is a refurbished Dell OptiPlex Gx620 with windows 7.   Is there a driver I can download to fix this Problem?

Pages: 1