Guest
Show Posts
1
General Mach Discussion / Interface between Labview and Mach3
« on: May 15, 2013, 12:27:43 PM »
Hi,
I have a CNC stage which is controlled by Mach3. I need to have a feed back control of the stage depending on the current values. If the current value becomes more than a set threshold value the stage should move down and this can be done by labview. But the problem is now the stage will be controlled by both labview and mach3 which would cause conflict. Can Mach3 get the current values from labview or any other source and do the feedback by itself? Like I can use IF loops in the CNC program depending on the value obtained? How should I proceed?
Thanks in advance,
Shiv.
I have a CNC stage which is controlled by Mach3. I need to have a feed back control of the stage depending on the current values. If the current value becomes more than a set threshold value the stage should move down and this can be done by labview. But the problem is now the stage will be controlled by both labview and mach3 which would cause conflict. Can Mach3 get the current values from labview or any other source and do the feedback by itself? Like I can use IF loops in the CNC program depending on the value obtained? How should I proceed?
Thanks in advance,
Shiv.