Guest
Show Posts
1
Mach3 and G-Rex / Mach3/G100 bug report - plugin V. 2.00.064
« on: May 07, 2007, 01:39:35 AM »
Found a couple of minor bugs on my first run of Steve Hardy's Xarach controller with Mach3 driving a Wabeco F1210E HS mill:
1) After running into a limit switch, say the Z-axis, on recovery pressing the X or Y keyboard jog arrows causes the Z to run back up into the limit.
If you start by jogging Z instead of another axis, the bug does not appear.
2) When rapid jogging using the keyboard arrows, if you let go of the shift key before the arrow key, it keeps on going and going and....
Otherwise its working very nicely and is cranking away behind me making a part right now.
Thanks,
George
1) After running into a limit switch, say the Z-axis, on recovery pressing the X or Y keyboard jog arrows causes the Z to run back up into the limit.
If you start by jogging Z instead of another axis, the bug does not appear.
2) When rapid jogging using the keyboard arrows, if you let go of the shift key before the arrow key, it keeps on going and going and....
Otherwise its working very nicely and is cranking away behind me making a part right now.
Thanks,
George