1
General Mach Discussion / How do I apply tool offset in Mach 3 turn?
« on: July 18, 2013, 07:50:21 PM »
Hi all, newbie here.
My problem is that I can't seem to apply my tool offsets. I have 4 tools in my tool table so far with the x and y offset values.
When I input G43 H2 (or H3 H4) into the MDI line, nothing happens.
I was expecting machine to move to the tool offset. Where am I going wrong?
Thanks
Richard
My problem is that I can't seem to apply my tool offsets. I have 4 tools in my tool table so far with the x and y offset values.
When I input G43 H2 (or H3 H4) into the MDI line, nothing happens.
I was expecting machine to move to the tool offset. Where am I going wrong?
Thanks
Richard