Hello Guest it is March 29, 2024, 08:53:30 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - aconstruction

Pages: 1
1
General Mach Discussion / Cycle timer
« on: June 15, 2013, 11:50:11 AM »
On the program-run screen under the tool information area there is a timer that shows elapsed time. This timer resets to zero each time a tool is changed and cycle start is pressed. I would like the timer to keep running until the end of the program to record an elapsed cycle time for the entire program.  Is this possible?  Thanks.

2
General Mach Discussion / Random wrong direction axis moves
« on: April 17, 2013, 09:42:18 PM »

I am getting random axis moves in the wrong direction.
It can occur on any axis and seems to happen at random times.
Usually everything works as it should but a couple times a day it will go the wrong way in the middle of a program that usually runs fine.
My setup is: Mach3, windows XP, CNC4PC C11 breakout board, automation technology drives

Thanks for any suggestions

Pages: 1