Hello Guest it is November 27, 2021, 03:44:41 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - builderco

Pages: 1
1
General Mach Discussion / Mach 3 personalization and full screen
« on: April 14, 2013, 03:19:09 PM »
Hi all

Can i use mach 3 in full screen mode?
 So we are using it in window mode and how can i take it to full screen or can i do it? :)

2
General Mach Discussion / Standalone DTHC Setup
« on: April 14, 2013, 10:32:35 AM »
Hi everyone;

I bought a new standalone THC unit for plasma. But I don't know how can i connect it to Mach 3.

I have two input and two output on my THC unit.;
1-Output from THC to controller. Arc Trans1 and Arc Trans2 to CNC input. That is dry contact relay connection.(I think that is arc OK signal.)
2-Input to THC unit. THC Auto and Arc on signal.(I think they are low effective)

So how should i connect that wires to PC. And if i ll connect the arc on signal to pin 5. How can i set up the pin 5 for arc on signal on mach3. And same thing for input signal. How can i set up the pin17 for arc OK signal and pin 18 for THC on/off signal.

How my THC Working;

Firstly Controller sending the arc on signal to THC and THC unit piercing the material. After pierce , THC sending a Arc OK signal to controller and controller sending movement signal to x and y axis' driver.

Notice: Actually I have two more cable but I don't know how is that working and is that input or output signal. That cables are up and down.

Sorry about my bad Eng. I ll wait help.

Thank you..

Pages: 1