Guest
Show Posts
1
General Mach Discussion / New User - Help Mach3 stopped at line 63
« on: April 10, 2013, 04:07:44 PM »
I am running the demo version of Mach3, but I did just purchase it a few hours ago, and it seems to work fine except a random stop.
I am new to CNC and just getting my feet wet. I searched the forums but it looks like the demo version stops at 500 lines and this whole file is only 271 lines. It is a pocket and a profile to cut out a 5" speaker.
When I run the file it goes fine until line 63 and then just stopped. When I hit run from here it did nothing and I couldn't see any error or problem on the screen. Also the program did not crash. I was able to bring up the MPG screen and bring the Z up and back the machine out of the part and move the cutting head out of the way with Mach3 control.
Is there any kind log or error log that gets written to that I can help debug this?
The Gcode was written with Vectric Cut2D.
I included the G-code below.
Thank you for your help and I apologize in advance if it was something simple I missed.
thanks
-david
I am new to CNC and just getting my feet wet. I searched the forums but it looks like the demo version stops at 500 lines and this whole file is only 271 lines. It is a pocket and a profile to cut out a 5" speaker.
When I run the file it goes fine until line 63 and then just stopped. When I hit run from here it did nothing and I couldn't see any error or problem on the screen. Also the program did not crash. I was able to bring up the MPG screen and bring the Z up and back the machine out of the part and move the cutting head out of the way with Mach3 control.
Is there any kind log or error log that gets written to that I can help debug this?
The Gcode was written with Vectric Cut2D.
I included the G-code below.
Thank you for your help and I apologize in advance if it was something simple I missed.
thanks
-david