Hello Guest it is November 27, 2021, 06:29:38 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Herecomestrouble

Pages: 1
1
General Mach Discussion / Mach 3 620 oz motor tuning? NEED HELP!!!
« on: April 08, 2013, 11:59:44 PM »
Hello, I'm new amd trying to figure out how to tune my 620 oz stepper motors to mach 3 for my plasma table.
I ordered a gantry from precision plasma and electronics from candcnc. I have the 620 oz motors. The gears I'm using measure 11/16 overall. There are15 teeth on the Gears.
I've been trying to figure out the math and been confused. I've got it close on mach but still off a bit.

Can anyone help me out for the settings on the tuning screen? So my gantry moves the correct measurements

Pages: 1