Hello Guest it is September 17, 2019, 11:44:25 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Brian Baudier

Pages: 1
1
General Mach Discussion / moveing z axis up and down
« on: October 05, 2007, 05:05:01 PM »
does anyone know about a stepper driver  , that will drive a stepper motor forward and reverse with out the use of a computer.   with a manual push button controller ,,:forward button and reverse button and speed.. simple and cheap...   to manual control my z axis..seperate from the computer driveing the x and y

2
General Mach Discussion / manual z axis
« on: May 05, 2007, 08:44:54 PM »
useing  mach 2 to control plasma table , just hooked up z axis. Can
anyone tell me if you can manual contol the z up and down while a
code is running.. if so how? setting up g code with sheet cam if
that matters...

Pages: 1