Guest
Show Posts
1
General Mach Discussion / Mach3 + Geckos 201 + C11
« on: May 06, 2007, 11:25:36 PM »
Hi there,
Im trying to build a cnc router, mechanics are almost done, but electronics are the weak part of the project because of my complete lack of experience.
First of all im trying to control a single axis (X axis), power supply delivers 72v, the stepper wiring diagram as follows:
RED/-WHT = phase 1
YEL/-GRN = phase 2
Communication with Arturo´s c11 is smooth, charge pump is fine, but when I send DIR and STEP signals, output leds flashes but theres no movement at all.
Any ideas?
Thanks in advance.
Im trying to build a cnc router, mechanics are almost done, but electronics are the weak part of the project because of my complete lack of experience.
First of all im trying to control a single axis (X axis), power supply delivers 72v, the stepper wiring diagram as follows:
RED/-WHT = phase 1
YEL/-GRN = phase 2
Communication with Arturo´s c11 is smooth, charge pump is fine, but when I send DIR and STEP signals, output leds flashes but theres no movement at all.
Any ideas?
Thanks in advance.