Hello Guest it is March 28, 2024, 08:53:53 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - BACK-INTO-RC

Pages: 1
1
Hello all, I'm fairly new to CNC, however I've been CAD'ing and running a PhlatPrinter for a couple of years.

My working machine is a 3-axis setup running a licensed copy of Mach3 (ver 2.6) under XP on a laptop with a USB connected smoothstepper.
I am nearing completion of a 4-axis foam cutter build.

I would like to run both machines from the same Mach3 installation. I have read over the Mach3 literature and searched the forums for information on this but have not found a discussion about this situation.

I know you can setup different profiles in a Mach3 installation, but do they allow you to run more than one machine?

Thanks for any help!!!

Pages: 1