Hello Guest it is March 28, 2024, 02:00:52 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - wmpinion

Pages: 1
1
General Mach Discussion / Mach 3 problem
« on: August 02, 2013, 07:02:06 PM »
Not sure if I'm posting in the right place. Please correct me. Thank you so much.  The problem I'm having is my z zero is changing during a run. It raises off work about 1/4 inch. My machine coordinate and z zero dro change together. The g code is ok and I have no slippage in the z axis.  Thanks for your help and if you can call me that would be fine. 8645562215


2
One on one phone support. / phone support please
« on: April 05, 2013, 12:22:34 AM »
my email is wmpinionwoodworking@gmail.com.   i an having problem with one axis turning correctly. it wants to only jog in one direction and is very jerky as though it is trying to go in the correct direction. i have narrowed it down to breakout board/pc/mach 3.   thanks  bill 

Pages: 1