Hello Guest it is April 11, 2021, 08:34:26 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Richpress

Pages: 1
1
SmoothStepper USB / Smoothstepper and G50/G51
« on: February 05, 2014, 08:30:37 PM »
Hello all,

Will the smoothstepper support G50 and G51 for axis scaling with Mach3?

Thanks,
Rich

2
General Mach Discussion / planet-cnc USB controller
« on: February 04, 2014, 07:10:21 PM »
Hello All,

I have a customer with set of motors and control box sourced by Probotix.   The control box has a planet-cnc USB control card as its input and stepper control.   The software provided does not do everything we need, and Mach3 will.    Is it possible to run the planet-cnc USB card with Mach3?

Richard

3
General Mach Discussion / RS232 fro gcode to serial port
« on: June 14, 2013, 06:05:20 PM »
Hello Group.

Is there a way to ASCII data from G-code to a serial port for RS232 communications between the Mach3 program and an external device?

Thank you in advance

4
I am configuring a new install of Mach3 with steppers and the parallel port.  I have the X-Y motors working fine but I need to assign pin8 and pin9 to specific M-functions.   How do I assign M3 to turn pin 8 on, and M5 to turn it off, and the same for pin 9 with and M#?

Also, where can I find information on customizing screens?

Pages: 1