1
General Mach Discussion / error marks in table display ??
« on: March 26, 2013, 09:58:43 AM »
I am running win 7 32bit and the latest version of mach 3 .. My steppers skip steps and loose their position. I do notice when this happens I get a white line in the toolpath on the table display .. what would be causing this ? MACH and machining is new to me ..
I was able to resolve some of the glitching bu shutting down services that had to do with driver detection and turning off interrupts ( irq) on the paralel driver ) I still get the problem though ... Also, I get an error in the driver test that oulse rate is " pulsing too fast"
how do i resolve this ?
thanks !
Voy
I was able to resolve some of the glitching bu shutting down services that had to do with driver detection and turning off interrupts ( irq) on the paralel driver ) I still get the problem though ... Also, I get an error in the driver test that oulse rate is " pulsing too fast"
how do i resolve this ?
thanks !
Voy