Guest
Show Posts
1
General Mach Discussion / MaxNC mode on gettoCNC
« on: March 26, 2013, 11:17:06 AM »
Hi to all,
I'm Robert, forum reader from 3 weeks, green guy in CNC but motivated. Recently I lay my hands on 6 scanners. Scanner have steppers, cnc mills have steppers, so I add 2+2 and made my simple gettoCNC machine. I ripped off motors, rails and driver pcb's. Hooked up straight to driver chip (AMtek AMM56219) and all went well.
However chip is quadrature driver, not simple step/dir so I use MaxNC mode in mach3 (radiobutton "Max CL mode enabled"). So far so good. After axis calibration I noticed that on low feed rates motor looses few steps and not going so smooth. When axis calibration routine is going all is smooth and - not very scientific method - it sounds right. But on normal operation on jog something is wrong. I made 2 vids, one on normal move, and on on axis calibration routine, please ignore few back and forth moves at the end of first video.
normal move http://www.youtube.com/watch?v=uCYioJk9Q1I
calibration http://www.youtube.com/watch?v=3ERmTMCraik
So my question, what is the difference betwen maxnc normal operation mode and axis calibration ? I try a lot feedrates but on anyone motors move so smooth as on calibration.Thx for help.
I'm Robert, forum reader from 3 weeks, green guy in CNC but motivated. Recently I lay my hands on 6 scanners. Scanner have steppers, cnc mills have steppers, so I add 2+2 and made my simple gettoCNC machine. I ripped off motors, rails and driver pcb's. Hooked up straight to driver chip (AMtek AMM56219) and all went well.
However chip is quadrature driver, not simple step/dir so I use MaxNC mode in mach3 (radiobutton "Max CL mode enabled"). So far so good. After axis calibration I noticed that on low feed rates motor looses few steps and not going so smooth. When axis calibration routine is going all is smooth and - not very scientific method - it sounds right. But on normal operation on jog something is wrong. I made 2 vids, one on normal move, and on on axis calibration routine, please ignore few back and forth moves at the end of first video.
normal move http://www.youtube.com/watch?v=uCYioJk9Q1I
calibration http://www.youtube.com/watch?v=3ERmTMCraik
So my question, what is the difference betwen maxnc normal operation mode and axis calibration ? I try a lot feedrates but on anyone motors move so smooth as on calibration.Thx for help.