Hello Guest it is March 28, 2024, 08:53:44 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - krafth

Pages: 1
1
General Mach Discussion / How to load DXF image correctly
« on: October 19, 2013, 04:42:33 AM »
Good day. I've tried to load the attached DXF image into LC to generate the Gcode, but I do not get the desired result. Can anyone explain what am I doing wrong. I need to cut the attached panels out of polystyrene foam. The machine I have designed can cut any soft material with the following dimensions; X=1750mm, Y=2750mm and Z=500mm maximum. The foam will lay flat in the machine, therefore the Gcode to be generated in such manner to enable the machine to cut the desired shapes.

Pages: 1