Guest
Show Posts
1
General Mach Discussion / Mach 3 mill overwrite ?
« on: March 21, 2013, 06:37:23 PM »
Hi ..I currently have a demo of the mach 3 mill version 3.043.22 and am interested in buying a licence and NFS add on ..Should i update to the new version Mach3 R3.0430.66 .Will this overwrite my older version so I can keep all of my settings ?.eveyrthing seems to be working fine but i do want to update ...The mill ,PC and controllers almost Ready to run was just recently purchased used with mach 3 mill installed ..I installed limit switches and did fine tuning ..Is it that big of deal to install Mach 3 from scratch ..Im concerned that if I go for a reinstall of mach 3 ,my mill could be down for a while
I just recently purchased a version of bobcad v21 expressed and the tech informed me that they have a compatible version of mach 3 specific for their software available..The only Problem is it will not overwrite my older version and I am not sure If I will end up staying with Bobcad software ..The tech did inform my that the bobcad version of Mach 3 was compatabe with other softwares as well...Regaudless of what version I get there are drivers available for bobcads cam software ..Any advice would be appreciated Thanks very much Lou
I just recently purchased a version of bobcad v21 expressed and the tech informed me that they have a compatible version of mach 3 specific for their software available..The only Problem is it will not overwrite my older version and I am not sure If I will end up staying with Bobcad software ..The tech did inform my that the bobcad version of Mach 3 was compatabe with other softwares as well...Regaudless of what version I get there are drivers available for bobcads cam software ..Any advice would be appreciated Thanks very much Lou