Hello Guest it is March 29, 2024, 09:10:37 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - digger66

Pages: 1
1
General Mach Discussion / Dwell / Pierce time with Plasma
« on: March 19, 2013, 07:59:58 PM »
I have just got my new cnc plasma table up and running, I have made a few cuts but have noticed that my plasma is not delaying for the pierce time. I am setting the pierce time in Bobcad24 as a second or fraction of - I tried bumping it up to 2 seconds but still no change - I am confident that it is something that I have to set correctly in the Mach 3 program - any advise or help would be appreciated. I am also running a THC on the plasma. ???
Thanx Jon

Pages: 1