Guest
Show Posts
1
General Mach Discussion / Changing step pulse waveform in Mach3?
« on: March 18, 2013, 05:28:28 AM »
Hello,
I use the IDX 7505 stepper motor driver from Trinamic. For every step this driver needs just one edge for each step of the motor. But Mach3 generates for every step an impulse of a constant length, that means there are two edges for each step. So I need a step signal that changes from low to high for the first step, changes back to low for the second step, changes back to high for the third step...I hope you understand. Is there any posibility to change the waveform of the step signal in this way?
I use the IDX 7505 stepper motor driver from Trinamic. For every step this driver needs just one edge for each step of the motor. But Mach3 generates for every step an impulse of a constant length, that means there are two edges for each step. So I need a step signal that changes from low to high for the first step, changes back to low for the second step, changes back to high for the third step...I hope you understand. Is there any posibility to change the waveform of the step signal in this way?