Hello Guest it is March 28, 2024, 04:25:24 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Zilna

Pages: 1
1
I have a C10 BOB with kl-4030 stepper drive and kl23h286-20-8b motors. The only power to the BOB is from my computer's parallel port as stated in the tutorial (I have tried it with the 5v power supply as well and no difference). I have wired the motors up matching the wires (wht/blue and blue) according to a wiring diagram that I found online for this motor. Wht/Blu and Blue to A+, Wht/Red and Red to A-, Wht/Grn and Grn to B+, and Wht/Blk and Blk to B-. I can still turn the motors. The switches on the stepper drive are set for 1/8 and 2.7v. I have gone through the settings in Mach3 according to the tutorial and still cannot get a single motor to move. Been racking our brains over this for 3 days now and am now just beyond frustrated. I know that some times the simplest solutions can make all the difference but I am out of ideas on how to make this work.

Pages: 1