Hello Guest it is May 28, 2020, 08:33:51 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - abernut

Pages: 1
1
General Mach Discussion / Dying PC options
« on: March 11, 2013, 02:01:06 PM »
The PC that currently has our MACH 3 software loaded on is about to crap the bed.

We have a new PC with the same OS ready but we are not sure what our options are to move the MACH 3 software.

Do we load the program from scratch and then copy some config files over, etc...??

Thanks,
Mike

Pages: 1