1
General Mach Discussion / Motor tuning mach 3 - mm? or inches?
« on: March 09, 2013, 10:12:35 AM »So I purchased one of those Chinese knock offs, it actually runs fairly well but I need some help... In Mach 3 they have you set it to mm, then motor tuning set steps to 400 , velocity to 2000 and accel to 200. This is for x and y. It works well enough, but I need inches! This is where I need help if I change Mach config to inches the cnc doesn't like it at all. Is the motor tuning in mm and need to be converted? Need help going from a mm setup to inches...
This is the cnc:
CNC 3020 Router ENGRAVER Drilling Milling Machine H | eBay
Heres the manual on my skydrive
http://sdrv.ms/10hAFR1
Any help is appreciated