Hello Guest it is December 05, 2023, 11:06:41 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - Ironic

Pages: 1
Hi guys.
Been reading this forum for some time now, learned a lot but I need help now that I could not find an answer on my own.

I would like to associate a script to a button. Something similar to E-stop, but that instead would do feedhold, stop spindle and raise the Z axis.
This is to stop program if i think the part is cut all the way trough, but still be able to resume if it is not.

I can do a script that does this, but it will not run if a program is running. I assume you can't run Gcode in a script while the main Gcode is running.

Any thoughts?

Pages: 1