Hello Guest it is July 28, 2021, 07:17:44 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - dhaxt

Pages: 1
General Mach Discussion / MPG
« on: April 13, 2008, 04:08:35 PM »
 When i hit the tab key to bring up the MPG controller i get mostly a black background and a few parts and buttons but can not use it. Any suggestons? It worked ok before so i have no notion as to what caused this.  Thought about uninstalling & reinstalling Mach to see if it would correct it. Win XP Pro


General Mach Discussion / New Problem
« on: July 23, 2007, 02:03:55 PM »
I have two computers with Mach 3 loaded. On both of them all at once the tool path when cutting a pocket from the wizards it shows a hesitation on the toolpath that you can see and also even show on the DRO's Happens about once per second. The one computeris in the house without any motors or drives connected to it. The other is out in the shop hooked to the mill. They are networked with ethernet cables through combo router-modem from dsl supplier. The only thing that i can think of that may have something to do with this is about the time this happened was when i tried to hook up a MicrosoftSidewinder Pro Plus joystick first on the one in the house then the one in the shop. Would not work. Before that it was working fine. I have uninstalled Mach and reinstalled on both computers but it still does the same thing. The one thing i did notice is that you can feel the hesitation on the motors when it does this. Is it possible that something got corrupted somewhere where even uninstalling and reinstalling would not catch.


General Mach Discussion / DRO
« on: July 20, 2007, 02:31:57 PM »
Whenever i start Mach i get readings on the DRO's and have to zero them before starting. Is this normal? Oh and by the way complete newbe here need lots of help. Also how would i go about posting a screen shot of what i am talking about?

Pages: 1