Topics

1

LazyCam (Beta) / lazy cam turn arc

« on: February 23, 2008, 09:49:53 PM »

Lazy cam turn has always put in G3 instead of G2.  So far I have always just done a find replace.
I'm not whether its a switch that i have set wrong or just the way it thinks.
I'm wonderiing if I was to change it to rear post would that fix it.
Mine is a front post.

any ideas.

Wes

2

General Mach Discussion / Charge pump pmdx 131

« on: June 08, 2007, 08:41:09 PM »

I was trying to finally hook up the charge pump and pin 17 keeps oscillating high to low at about 1 HZ
works fine when i first start up then i close and reopen Mach and it starts oscillating

Wes