Hello Guest it is March 28, 2024, 05:59:07 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - machinistman88

Pages: 1
1
General Mach Discussion / Cnc plasma issue. delayed start troubles
« on: May 03, 2013, 04:47:39 PM »
I'm having issues with my cnc plasma table and have no clue where to start. My issue is there is a delay in mach 3 when my plasma cutter pierces to start a cut. Once it pierces, it delays long enough that I loose my arc when I have my cutter set on its normal cut mode. The only way I can keep the arc going long enough for the table to start moving is to have my plasma cutter set in gouge mode, which creates an awful cut and burns my consumables up quick. I'm running a hypertherm powermax 1000 on a 4x8' Eagle plasma table with a Proma THC. I'm using sheetcam to create my gcode and have pierce delay set at 0. Is there any way I can fix this in mach 3??thanks!!

Pages: 1