Topics

1

General Mach Discussion / mach 3 turn doubt

« on: February 07, 2013, 05:44:27 AM »

hi everyone,

i am new to mach3 turn.

is there a option to bring the tool to the starting position(xz origin/program zero)

how does (zero world in x&z) work in program coordinate.

what is the difference between program coordinate & part coordinate home buttons.

if i am not clear with the question  please revert back . Urgent  need reply .....

-----------------------------------------------------
regards
adhityan
INDIA

2

General Mach Discussion / g41&g42 doubt

« on: February 05, 2013, 01:31:50 AM »

hi to all,

i am using latest Mach3 version  R3.043.067. i problems that i face

1)when tool compensation g41 or g42 is used the inner circle dosent seem to close when i stimulate & also run it online using machine.
i have attached the g code and screen short of the eg files.
[sq size50x50 with fillet 5mm and inner 20 dia circle]

2)the reverse run command also dosent work well. please clarify how to use this command.
-----------------------------
regards,
adhityan
INDIA.