Hi Everybody;
I am trying to connect a standalone THC to my plasma cutter. May u know how standalone thc working but there is an some information;
Mach sends arc start signal to thc and waits for arc ok signal. Thc does ihs(initial height sensing) with ohmic sensor or floating head switch and pierces the material. After pierce sends to arc ok signal mach 3 for move....
So I set-up everything, I did some test and everything working well. But at the corners...
THC diving at the corners.
Because feedrate is getting lower at the corners. Mach 3 has anti dive function for that but i couldnt set up that for standalone thc. Maybe I can connect the Anti-Dive function to any output(relay). And relay sends a thc on/off(enable) signal to thc at the corners.
So can i send an output signal when anti dive is active.
I am gonna wait ur early replies.
Thank You
Furkan