Hello Guest it is April 10, 2021, 10:12:48 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - dpcwright

Pages: 1
1
General Mach Discussion / Syil X7 and Mach 3
« on: March 18, 2014, 08:11:37 AM »
I have a syil x7 cnc milling machine which has stopped working.
I have not used it for six months due to illness
I load Mach 3 and use the profile which I was supplied with by Syil,(attached below) I then load the smart stepper and then cannot clear the Estop, if I activate the actual machine e stop and reset it I can then clear the estop in Mach 3 however if I run any G code the machine does not operate at all.
I confess to being a complete novice with cnc so please treat me gently but I really need some help

Pages: 1