Hello Guest it is March 28, 2024, 10:00:58 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - cncmay

Pages: 1
1
I am new to Mach3.  I have used it to control my 3 axis machine.  I am trying to use the backlash compensation.  When I activate backlash compensation the compensation is applied to the reversing axis but at the same time the other axis slows to a stop and then accelerates.  This causes the feed rate on a circular move to be non constant.  Is there anything that can be done?

Pages: 1