Guest
Show Posts
1
General Mach Discussion / HELP NEEDED URGENT
« on: January 15, 2013, 07:46:27 AM »
I have bought and assembled a driver unit with onboard regulated power supply for Nema 24 motors.
System4c unit info :
http://www.diycnc.co.uk/SYS4C.pdf
http://diycnc.co.uk/html/wiring.html
I have it all wired up and assembled, it should be plug in and play.
My mach3 is working fine and I am able to jog.
My issue is that when I want to test the jog on my motors, i plug my system into the PC using the PC port.
Change my motor output pins as suggested in the unit manual but NOTHING is happening. The DRO's still change but my motors are silent and still.
I'm really at a loss as to what the problem is. PLEASE HELP.
See my mach3 settings here
What am I doing wrong?
System4c unit info :
http://www.diycnc.co.uk/SYS4C.pdf
http://diycnc.co.uk/html/wiring.html
I have it all wired up and assembled, it should be plug in and play.
My mach3 is working fine and I am able to jog.
My issue is that when I want to test the jog on my motors, i plug my system into the PC using the PC port.
Change my motor output pins as suggested in the unit manual but NOTHING is happening. The DRO's still change but my motors are silent and still.
I'm really at a loss as to what the problem is. PLEASE HELP.
See my mach3 settings here
What am I doing wrong?
