Hello Guest it is December 06, 2019, 11:19:02 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - hardeepkim

Pages: 1
1
Mach3 and G-Rex / feed rate overrun
« on: January 12, 2013, 09:40:40 AM »
 hello every one
 i m new to mach 3, i have assembled all parts n used mach 3 trial version, axis do not move as fast as they should or as fast i want  them to move, feed rate it show is 6, then for the given program it simulated expected time say 60 minutes,
then i selected max feed rate over run it show 18...or 300% but still it is slower, simulation expected time show about 40 minutes,it is still not satisfactory, i want to know if paid  version of mach 3 allows  feed rate overrun more than 300%,[[ my program involves interpolation.. and i have tried  by changing velocity and acc time in motor config for each axis ]]
  plz  reply soon  thanks

Pages: 1