Topics

1

General Mach Discussion / Disable Generating Path on file load

« on: September 13, 2013, 11:53:04 AM »

Is there a way to disable Generating Path on file load? I am running Mach on a 3D printer and I am maxing out the specs on the laptop I use. File sizes are over 200MB.
If I hit cancel when the Generating Path dialog displays after the file loads, I can run the gcode without a problem. I regularly turn off the Tool Path display on these larger files as well.

thanks

2

General Mach Discussion / M code for e-stop

« on: January 17, 2013, 04:25:30 PM »

Is there a valid M code for E-stop? Wiki shows M112, but that doesn't seem to work in Mach3.

3

General Mach Discussion / Disable E-stop on file load

« on: January 14, 2013, 06:51:12 PM »

Is there a way to disable the E-stop trigger when a file is loaded? I am using Mach3 on a Reprap style 3d printer, and control my heated elements with the spindle relay. When the E-stop is triggered, I have to wait for my heater PID controllers to cycle and come back to temperature.