1
General Mach Discussion / THC problems
« on: December 13, 2012, 05:39:52 PM »
I have never got my thc to work and i think i have tried everything possible.
Here is what it does, it shows the actual cut voltage but doesn't move the torch when the voltage changes and sometimes it will all of a sudden move it up but wont move it back down.
I was told i might have a port conflict but cant find out much info, i did find this but have to idea what it means. I am using candcnc electronics.
Here is what it does, it shows the actual cut voltage but doesn't move the torch when the voltage changes and sometimes it will all of a sudden move it up but wont move it back down.
I was told i might have a port conflict but cant find out much info, i did find this but have to idea what it means. I am using candcnc electronics.