Guest
Show Posts
1
PoKeys / Connecting POKEYS56E to Leadshine 542 Drivers
« on: December 10, 2012, 11:08:19 AM »
Hi all,
i am new here and want to say hello to you:-) I am not very experienced in stepper driver and its connection.
I just tried to connect my Pokeys56E to MACH3. As far as good, the encoder and switches are working for now.
But what i don't undersatnd is, how can i connect the stepper drivers to the Pokeys card?
The driver has two PULL, two DIR and two ENABLE entries, but the Pokeys offer 1 DIR and 1 STEP ouput.
Has anyone a connection shematic about the wiring and can help me out with it please? Would be very appricated:-)
Regards
Thomas
i am new here and want to say hello to you:-) I am not very experienced in stepper driver and its connection.
I just tried to connect my Pokeys56E to MACH3. As far as good, the encoder and switches are working for now.
But what i don't undersatnd is, how can i connect the stepper drivers to the Pokeys card?
The driver has two PULL, two DIR and two ENABLE entries, but the Pokeys offer 1 DIR and 1 STEP ouput.
Has anyone a connection shematic about the wiring and can help me out with it please? Would be very appricated:-)
Regards
Thomas