Topics

1

General Mach Discussion / spindle relay

« on: September 22, 2013, 01:52:54 AM »

I have a cnc router that I control with mach3.  While trying to figure out my pins and ports I must have turned off the signal to the relay that turns on the power to the spindle.  I can't seem to figure out what I did or how to fix it.  Any thoughts?

Thanks  Bob

2

General Mach Discussion / Install help for mach3

« on: December 09, 2012, 02:01:08 PM »

I bought a used cnc router from a private party.  I saw the machine in operation and know it works.  I purchased a Mach3 program and lic. and thought it would be a plug and play deal.  Boy was I wrong.  I have installed the software and got it to run in the computer.  I just can not get the computer to talk to the router.  In the dig. scrn, the ports do not light up and I can access the motor tuning.  Any help would be appreciated.

Bob