Topics

1

General Mach Discussion / MOD mach3

« on: March 05, 2010, 07:27:12 PM »

How to make keyboard buton can chang feed rate overdrive?

thanks and regards

2

General Mach Discussion / Mach3 modify question

« on: November 26, 2009, 12:05:08 AM »

How mach3 can wait extranal input when mach3 finish one line code?

thanks alote 

3

Promote and discuss your product / 6A/80V unipolar microstep driver, poll price you hope

« on: November 19, 2009, 11:59:19 AM »

Spec
-Maximum motor voltage: 80VDC
-Peak current: 6A per phase (4.2A RMS)
-Micro step models: Full step, haf step, micro-step 4, 8, 16, 5, 10
-Opto-isolated step/direction
-Auto reduce current while motor is stopped
-80khz maximum step pulse -frequency
-Internal socketed fuse
-Single supplier
-Microstep to full step morphing at higher speeds
Place: Houston USA


PRICE YOUR WANT? pleas vote.

thanks and regards


Compare size , Driver and 23 size stepper motor

4

General Mach Discussion / PC hardware for mach

« on: January 25, 2008, 09:45:40 AM »

this PC can good using for mach?

P3 800

SDRam 128

Hdd 10GB

CDrom

VGA (DVI)– Sound – Lan On

5

General Mach Discussion / Spindle speed control

« on: January 19, 2008, 05:28:37 AM »

how to automatic control spindle speed with this motor? any try it?

6

General Mach Discussion / Spindle control

« on: January 19, 2008, 12:29:51 AM »

How to setting mach 3 control spindle just on and off? thanks for your help

7

General Mach Discussion / Can use both LTP Port

« on: August 15, 2006, 09:26:13 AM »

I want use both LTP 1 and LTP 2, because i want use encoder for xyz axis. Need too much input, 1 LTP just have 5 input. If i use LTP 2 port I have more than 17 input. That right?