1
General Mach Discussion / The Results :
« on: December 16, 2012, 10:56:43 AM »
A little while back I wanted to use a rotary table as a "Poor Man's Turret CNC"
With the help of Hood this is the result. Also the tool wear offset has been changed so that
you make the part BIGGER by + tool wear, SMALLER by - tool wear (same as Okuma, Hass, etc.
JR
http://www.youtube.com/watch?v=sMU7Iwl7IeA
With the help of Hood this is the result. Also the tool wear offset has been changed so that
you make the part BIGGER by + tool wear, SMALLER by - tool wear (same as Okuma, Hass, etc.
JR
http://www.youtube.com/watch?v=sMU7Iwl7IeA