1
General Mach Discussion / When I click Feed Hold, then move Z, then Cycle Start - does not resume properly
« on: November 20, 2012, 11:48:32 PM »
Here's my issue.
If I'm machining a part, then click on Feed Hold, then move the Z up manually - say to clear the bit or change the bit (not touching X or Y) - then click on Cycle Start I expect the machine to move back to the appropriate Z height, then carry on. Instead, it moves the X AND Y AND Z axis' and carries on. Any idea what could be causing this?
Thanks,
Rich
If I'm machining a part, then click on Feed Hold, then move the Z up manually - say to clear the bit or change the bit (not touching X or Y) - then click on Cycle Start I expect the machine to move back to the appropriate Z height, then carry on. Instead, it moves the X AND Y AND Z axis' and carries on. Any idea what could be causing this?
Thanks,
Rich