Hello Guest it is November 29, 2022, 02:52:28 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - wirsboguy

Pages: 1
1
Hi, I have Mitsubishi servo's and drives, the drives are MR-J2S. Do I need a motion controller or just a breakout board to get this up and running? I want to use Mach 3 and have been confused by alot of "advice". Thank you for any assistance you can provide me with the wiring, and other hardware needed.

2
Galil / Which Galil to use??
« on: November 20, 2012, 05:29:27 PM »
I Have Mitsubishi MR-J2S-40A Drive and corresponding motors. What would be the easiest controller to use with them and Mach 3?
Thanks.

Pages: 1